Q: Vehicle not starting.

There is a good chance that the door handle assembly needs to be replaced. The fact that the handle works well from the outside indicates the linkage is working properly. Without seeing the handle, however, I couldn't be 100% certain....

Hello. If the vehicle has aftermarket wheels on it then they may have the wrong offset which will cause this. If the wheels are original then the rear suspension needs to be checked for worn parts. If the suspension is...

是的，从您描述的情况下，ABS模块似乎有问题。闪光灯表明已经出现问题，并且ABS系统被禁用。车辆仍应制动并停止...

This may be caused by a variety of reasons, but the slow acceleration (//m.whoreclub.com/services/car-is-slow-to-accelerate-inspection) suggests that you potentially have a clogged catalytic converter (//m.whoreclub.com/services/catalytic-converter-replacement) which could cause overheating (//m.whoreclub.com/services/car-is-overheating-inspection). I would definitely not recommend driving it under this condition. I...

Hello. The wheel spacers are what is causing this. Once you change the placement of the wheels like this, it changes the geometry of the suspension which causes it to act like this. If there are any worn out parts...

Hi there. The P0441 trouble code (//m.whoreclub.com/article/p0441-obd-ii-trouble-code-evaporative-emission-control-system-incorrect-purge-flow-by-spencer-clayton) will be seen when the ECU has detected incorrect purge flow in the Evaporative (EVAP) emission control system. When the purge flow is determined to be faulty, a Check Engine Light is set...

Neither the strut assembly, nor the individual assembly components, for those two models in that year do NOT interchange in any parts catalogs and thus these parts cannot be interchanged on the two Hyundai models. YourMechanic (//m.whoreclub.com) can obtain the...

At 140,000 miles, it really could be just about anything. It could be that there is an electrical component that takes some time to heat up and fail, but works again as soon as it cools off for a few...

Code P0730 relates to an incorrect reading between the input RPM speed sensor and the output speed of the transmission RPM sensor. When this happens, the ECM will produce this code indicating a fault has been detected. Code P0128 relates...