Is it time to install new speakers? If you hear rattling or excessive humming or buzzing coming from your car speakers, it may be time to更换旧扬声器. Or, if you are looking for extra volume, you may want to add additional speakers. To install speakers to your car stereo system, you will need to tie the wiring into the current speakers. It is a simple process that you can do by following the steps below. Here's how to install additional car speakers:
How to install car speakers
Gather the correct materials- You will have to gather the right materials first. You will need the following: Power drill with ¼” drill bit, Quick-splice wire connectors (recommended: Cal-Hawk Quick Splice Connector Assortment), Screwdriver set, and a Socket set and ratchet (¼” drive)/
卸下扬声器覆盖面板- You will need to remove the speaker covering panel closest to the location you wish to mount your additional speakers**. Follow the process used in Part 2 of this tutorial to remove the panel.
Determine where you will run the wire- Figure out where you will run your wire from the new speaker to the existing speaker location. Ideally, you will want to run the wire in a hidden location.
Tip：检查面板下方是否有一个空隙，您要在其中安装可以在其中运行电线的扬声器。
Note: If you are not able to route the wire under the panel in a hidden location, you may want to reconsider your speaker placement. Alternatively, you can run the wire along the surface of the panel though it will not be as attractive nor protected.
通过面板钻一个孔以路由电线- Carefully drill through the panel with a ¼” bit. Use low speed if you can and very light pressure. As soon as the bit penetrates all the way through, pull the drill bit back out.
将电线穿过孔- Gently pull the wires for your new speaker through the hole then fasten the speaker in place. The speaker itself will cover the hole you drilled through the panel.
Tip：可以用螺钉固定扬声器，也可以使用重型两面胶带将其固定在适当的位置。使用新扬声器随附的紧固件安装它们。
Connect the new speaker’s wires to the existing speaker’s wires- Use quick-splice connectors to easily connect the wires. Put one side of the quick-splice connector over the existing speaker wire. Put the end of the new speaker’s wire into the quick-splice connector.
Snap in place- 将连接器牢固地压在一起，直到将其捕捉到位。快速切割连接器穿透电线上的绝缘材料，并在两条电线之间建立可靠的连接。它们通常用于配件安装和汽车音频安装中。
正确组织布线- 小心面板下方的任何电线，选择一个不会被紧固件捏住的位置或擦在金属或塑料上。
重新安装现有扬声器的封面- Install all the screws and trim clips in the reverse order of removal.
总体而言，更换或添加扬声器的过程相对简单，如果遵循上面的指南，则应该能够成功完成任务。但是，如果您一路上遇到任何问题，您可以始终Ask a Mechanic.
或者，如果您不愿意自己执行这项工作，那么您可以致电一名认证技术人员at YourMechanic to come to your home or office.
