现代图森轮轴承在您的家庭或办公室更换。

力学如何更换车万博亚洲客户端轮轴承？

车轮轴承更换的复杂性取决于车辆的制造，型号，年份，车轮位置（前后）和驱动器类型（AWD对FWD）：

• 在带有统一轮轴承/轮毂组件的车辆上，卸下制动转子和卡尺。
• 卸下大轴螺母，将轴向后通过统一轮毂组件的中心向后推，并将固定轮毂组件的三个（或更多）螺栓移至方向指关节。
• The hub assembly is then removed from the knuckle. On installation of the new hub assembly to the knuckle, the bolts are torqued to the factory specification. In many cases, it is required to discard the old axle nut and replace with a new one. Special attention must be given to tightening the axle nut to the exact factory specification because over or under-tightening can damage the newly installed bearing. All YourMechanic professionals use calibrated torque wrenches on these critical fasteners.
• 最后，重新连接制动转子和制动卡钳，安装了车轮，并经过了路测试。
• On vehicles where the wheel bearing is pressed into a cavity within the steering knuckle, the steering knuckle must be removed from the vehicle in order to press out the old bearing and press in the new bearing.
• 在某些车辆上，将车轮轴承按在车轴上，因此必须从轴载体中提取轴。这将适用于某些卡车。